![]() ![]() This feature is disabled by default and should remain disabled when all access points are installed.Īdditional information about OTAP is available on at the following link: If this feature is enabled on the controller, all joined access points transmit wireless CAPWAP neighbor messages, and new access points receive the controller IP address from these messages. Over-the-air provisioning (OTAP)-This feature is supported by Cisco 4400 series controllers.Layer 3 CAPWAP discovery-Can occur on different subnets than the access point and uses IP addresses and UDP packets rather than MAC addresses used by Layer 2 discovery.The access point supports these controller discovery processes: If the controller is set to a time that has already occurred, the access point might not join the controller because its certificate may not be valid for that time.Īccess points must be discovered by a controller before they can become an active part of the network. Note Make sure that the controller is set to the current time. – Radio hardware is capable of explicit compressed beamforming (ECBF) per 802.11n standard – Cisco Vector Beamforming-Implicit Co-phase beamforming for.11ag clients and 1 spatial-stream and 2 spatial-stream clients – DPD (Digital Pre-Distortion) technology 2.4 GHz and 5 GHz 802.11n radios with the following features:.– Throughput, forwarding, and filtering performance scaled to meet 3 spatial stream, 450 Mbps data-rates – BandSelect (not available on autonomous or standalone models) – Management Frame Protection (MFP) (not available on autonomous or standalone models) ![]() – Rogue detection (not available on autonomous or standalone models) – Radio Resource Management (RRM) (not available on autonomous or standalone models) – WIDS/WIPS (not available on autonomous or standalone models) – Location (not available on autonomous or standalone models) – VideoStream (available only in WGB mode for autonomous or standalone models) – ClientLink 2.0-BeamForming to 802.11n clients as well as legacy 802.11a/g OFDM clients – CleanAir-Automatic detection, classification, location and mitigation of RF interference (not available on autonomous or standalone models) Processing sub-systems (including CPUs and memory) and radio hardware which supports:.For information on supported regulatory domains, see “Regulatory Domains” section. Note The ‘x’ in the model numbers represents the regulatory domain. Obtaining Documentation and Submitting a Service Request Operation of Cisco Aironet Access Points in BrazilĬonfiguring DHCP Option 43 and DHCP Option 60 This Device Meets the Industry Canada Guidelines for Exposure to Radio WavesĬet appareil est conforme aux directives internationales en matière dqexposition aux fréquences radioélectriquesĪdministrative Rules for Cisco Aironet Access Points in Taiwan This Device Meets FCC Guidelines for Exposure to Radio Waves This Device Meets International Guidelines for Exposure to Radio Waves Guidelines for Operating Cisco Aironet Access Points in JapanĮuropean Community, Switzerland, Norway, Iceland, and Liechtensteinĭeclaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EECĭeclaration of Conformity for RF Exposure Manufacturers Federal Communication Commission Declaration of Conformity Statement Troubleshooting the Access Point Join Processĭeclarations of Conformity and Regulatory Information Guidelines for Using Cisco Aironet Lightweight Access Points Performing a Pre-Installation Configurationĭeploying the Access Point on the Wireless Network
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |